Compact Cost-Efective 24 Vdc, 10 A NAC Power Supply and Battery Charger FIRE-LITE FL-PS10

0 out of 5

Compact Cost-Efective 24 Vdc, 10 A NAC Power Supply and Battery Charger

$594.09

Availability: 10 in stock SKU: FL-PS10 Categories: , , ,

Reviews Summary by AI:

Description

okAvailable Stock USA

Downloads:

FL-PS10

General The PS Series is a remote power supply line from Fire•Lite Alarms and is a direct replacement for the FCPS-24FS6/8 Series. The FLPS6(C) is a 6 amp and the FL-PS10(C) is a 10 amp, remote power supply with battery charger that may be connected to any 12 or 24 volt fire alarm control panel (FACP) or used as a standalone power supply. The PS Series provides 24 VDC power for NACs (notification appliance circuits) configured as either Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options. The PS Series also provides auxiliary power, constant or resettable, suited for detectors, annunciators, door holders, and other fire alarm system peripherals. The PS Series cabinet can hold two 7 AH or 18 AH batteries and can charge up to 33 AH batteries in a separate cabinet.

 

Features
 
• Up to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for: – Class B and/or Class A NACs – Class B and/or Class A resettable or non-resettable 24V auxiliary power – door holder power
• Converts from Class B to Class A wiring without losing any outputs using the ZNAC-PS converter card (sold separately)
• Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power
• Configurable for ANSI® Temporal 3 or Temporal 4 coded output
• UL-Listed NAC synchronization using System Sensor®, Wheelock®, Gentex®, or AMSECO® appliances
• Synchronization can be triggered from FACP NAC/remote sync outputs, cascaded power supply, or a control module, single or multi, which may be housed within the power supply cabinet
• Ability to cascade up to four power supplies
• Two (6 amp model) or three (10 amp model) fully-isolated input/ control circuits which can be programmed to any output
• Two Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only
• 6 or 10 amp full load output, respectively, with 3 A maximum/circuit
• Individual NAC power and trouble LEDs for diagnostic efficiency
• Trouble history modes for diagnostic support
• Wide range end-of-line supervision value (normal: 2K-27K ohms) • Selectable earth fault detection (enable or disable)
• AC trouble report delay timer
• Completely configurable via onboard DIP switches, no extra software required
• Self-contained in compact, locking cabinet constructed of heavy gauge steel with a corrosion-resistant powder coat chip and scratch-resistant finish
• Cabinet designed with ten double knockouts and a removable door for ease of installation and wiring
• Includes integral battery charger capable of charging up to 33 AH batteries
• Cabinet can house two 7 AH or 18 AH batteries.
 
Standards and Codes
 
The FL-PS Series comply with the following standards:
 
• NFPA 72 National Fire Alarm Code
• UL 864 Standard for Control Units for Fire Alarm Systems (NAC expander mode), 10th Edition
• UL 1481 Power Supplies for Fire Alarm Systems
• IBC 2009 (when using SEISKIT-MULTI-1)
• CBC 2007 (when using SEISKIT-MULTI-1)
 
Agency Listings and Approvals
 
These listings and approvals apply to the modules specified in this document. In some cases, certain approval agencies may not list certain modules or applications, or listing may be in process. Consult the factory for the latest listing status.
 
• UL Listed: S2424
• ULC Listed: S2424 (FL-PS6/10C)
• CSFM Approved: 7315-0075:0510
• FDNY Approved
• FM Approved 
 

Additional information

Weight 21.21 oz
Category:

Sub Category 1:

Sub Category 2:

Brand

FIRE-LITE

Created

28/9/2024, 1:46 AM

Country:

Related Products